(Redirected from Meter):''This article is about the unit of length. For other uses of ''metre'' or ''meter'', see ''
meter (disambiguation)''.''
The 'metre' (American English: 'meter') is a measure of
length. It is the
basic unit of
length in the
metric system and in the
International System of Units (SI), used around the world for general and scientific purposes. Historically, the metre was defined by the
French Academy of Sciences as the length between two marks on a platinum-iridium bar, which was designed to represent 1/10,000,000 of the distance from the equator to the north pole through Paris. Today, it is defined by the
International Bureau of Weights and Measures as the distance travelled by
light in absolute
vacuum in 1/299,792,458 of a
second.
The symbol for metre is 'm'. Decimal multiples and submultiples of the metre, such as ''
kilometre'' (1000 metres) and ''
centimetre'' (1/100 metre), are indicated by adding
SI prefixes to ''metre'' (see
table below).
Etymology
The word '' is from the Greek ''metron'' (), "a " via the French ''mètre''. Its first recorded usage in English meaning this unit of length is from 1797.
History
Meridional definition
In the eighteenth century, there were two favoured approaches to the definition of the standard unit of length. One suggested defining the metre as the length of a
pendulum with a half-
period of one
second. The other suggested defining the metre as one ten-millionth of the length of the Earth's
meridian along a quadrant, that is the distance from the equator to the north pole. In 1791, the
French Academy of Sciences selected the meridional definition.
In order to establish a universally accepted foundation for the definition of the metre, measurements of this meridian more accurate than those available at that time were imperative. The
Bureau des Longitudes commissioned an expedition led by
Delambre and
Pierre Méchain, lasting from 1792 to 1799, which measured the length of the
meridian between
Dunkerque and
Barcelona. This portion of the meridian, which also passes through
Paris, was to serve as the basis for the length of the half meridian, connecting the
North Pole with the
Equator.
However, in 1793, France adopted the metre based on provisional results from the expedition as its official unit of length. Although it was later determined that the first prototype metre bar was short by a fifth of a millimetre due to miscalculation of the flattening of the Earth, this length became the standard. So, the circumference of the
Earth through the poles is approximately forty million metres.
Prototype metre bar

Historical ''International Prototype Metre'' bar, made of an alloy of platinum and iridium, that was the standard from 1889 to 1960.
In the 1870s and in light of modern precision, a series of international conferences were held to devise new metric standards. The
Metre Convention (Convention du Mètre) of 1875 mandated the establishment of a permanent
International Bureau of Weights and Measures (BIPM: Bureau International des Poids et Mesures) to be located in
Sèvres, France. This new organisation would preserve the new prototype metre and
kilogram when constructed, distribute national metric prototypes, and maintain comparisons between them and non-metric measurement standards. This organization created a new prototype bar in 1889 at the first
General Conference on Weights and Measures (CGPM: Conférence Générale des Poids et Mesures), establishing the ''International Prototype Metre'' as the distance between two lines on a standard bar of an alloy of ninety percent
platinum and ten percent
iridium, measured at 0 degrees Celsius
Standard wavelength of krypton-86 emission
In 1893, the standard metre was first measured with an
interferometer by
Albert A. Michelson, the inventor of the device and an advocate of using some particular
wavelength of
light as a standard of distance. By 1925,
interferometry was in regular use at the BIPM. However, the International Prototype Metre remained the standard until 1960, when the eleventh
CGPM defined the metre in the new
SI system as equal to 1,650,763.73
wavelengths of the
orange-
red emission line in the
electromagnetic spectrum of the
krypton-86
atom in a
vacuum. The original international prototype of the metre is still kept at the BIPM under the conditions specified in 1889.
Standard wavelength of helium-neon laser light
To further reduce uncertainty, the seventeenth CGPM in 1983 replaced the definition of the metre with its current definition, thus fixing the length of the metre in terms of
time and the
speed of light:
:''The metre is the length of the path travelled by light in vacuum during a time interval of 1/299 792 458 of a second.''
[1]
Note that this definition had the effect of fixing the speed of light in a vacuum at precisely 299,792,458 metres per second. Although the metre is now ''defined'' in terms of time-of-flight, actual laboratory realisations of the metre are still ''delineated'' by counting the required number of wavelengths of light along the distance. An intended byproduct of the 17
th CGPM’s definition was that it enabled scientists to measure the wavelength of their lasers with one-fifth the uncertainty. To further facilitate reproducibility from lab to lab, the 17
th CGPM also made the iodine-stabilised Helium-Neon laser "a recommended radiation" for realising the metre.
[2] Today's best determination of the wavelength of this laser is λ
HeNe = 632.991
398
22 nm with an estimated relative standard uncertainty ''(U)'' of ± 2.5 × 10
-11. This uncertainty is currently the limiting factor in laboratory realisations of the metre as it is several orders of magnitude poorer than that of the second (''U'' = 5 × 10
-16)
[3]. Consequently, a practical realisation of the metre is usually delineated (not defined) today in labs as 1,579,800.298
728 ± 0.000
039 wavelengths of Helium-Neon laser light in a vacuum.
Timeline of definition
★
1790May 8 — The
French National Assembly decides that the length of the new metre would be equal to the length of a
pendulum with a half-
period of one
second.
★
1791March 30 — The French National Assembly accepts the proposal by the
French Academy of Sciences that the new definition for the metre be equal to one ten-millionth of the length of the Earth's
meridian along a quadrant through Paris, that is the distance from the equator to the north pole.
★ 1795 — Provisional metre bar constructed of
brass.
★
1799December 10 — The French National Assembly specifies the platinum metre bar, constructed on
23 June 1799 and deposited in the
National Archives, as the final standard.
★
1889September 28 — The first
General Conference on Weights and Measures (CGPM) defines the length as the distance between two lines on a standard bar of an alloy of
platinum with ten percent
iridium, measured at the melting point of ice.
★
1927October 6 — The seventh CGPM adjusts the definition of the length to be the distance, at 0 °
C, between the axes of the two central lines marked on the prototype bar of platinum-iridium, this bar being subject to one standard
atmosphere of pressure and supported on two cylinders of at least one centimetre diameter, symmetrically placed in the same horizontal plane at a distance of 571 millimetres from each other.
★
1960October 20 — The eleventh CGPM defines the length to be equal to 1,650,763.73
wavelengths in
vacuum of the
radiation corresponding to the transition between the 2p
10 and 5d
5 quantum levels of the
krypton-86
atom.
★
1983October 21 — The seventeenth CGPM defines the length as equal to the distance travelled by
light in
vacuum during a time interval of 1/299 792 458 of a
second.
SI prefixed forms of metre
SI prefixes are often employed to denote decimal multiples and submultiples of the metre. The most commonly used factors of metre are listed below in 'bold'.
| 'Factor' | 'Name' | 'Symbol' | | 'Factor' | 'Name' | 'Symbol' |
| 10−1 | decimetre | dm | | 101 | decametre | dam |
| 10−2 | 'centimetre' | cm | | 102 | hectometre | hm |
| 10−3 | 'millimetre' | mm | | 103 | 'kilometre' | km |
| 10−6 | 'micrometre' ('micron') | µm | | 106 | megametre | Mm |
| 10−9 | 'nanometre' | nm | | 109 | gigametre | Gm |
| 10−12 | picometre | pm | | 1012 | terametre | Tm |
| 10−15 | femtometre (fermi) | fm | | 1015 | petametre | Pm |
| 10−18 | attometre | am | | 1018 | exametre | Em |
| 10−21 | zeptometre | zm | | 1021 | zettametre | Zm |
| 10−24 | yoctometre | ym | | 1024 | yottametre | Ym |
Equivalents in other units
Metric unit expressed in non-SI unit | Non-SI unit expressed in metric unit |
|---|
| 1 metre | ≈ | 10−4 | mil | | 1 mil | ≡ | 104 | metres | |
| 1 metre | ≈ | 39.37 | inches | | 1 inch | ≡ | 0.0254 | metres | |
| 1 centimetre | ≈ | 0.3937 | inch | | 1 inch | ≡ | 2.54 | centimetres | |
| 1 millimetre | ≈ | 0.03937 | inch | | 1 inch | ≡ | 25.4 | millimetres | |
| 1 metre | ≡ | 1×1010 | Ångström | | 1 Ångström | ≡ | 1×10-10 | metre | |
| 1 nanometre | ≡ | 10 | Ångström | | 1 Ångström | ≡ | 100 | picometres | |
See also
★
SI (International System of Units)
★
Convention du Mètre
★
SI prefix
★
Conversion of units for comparisons with other units
★
Orders of magnitude (length)
★
Speed of light
★
metrification
References
★ Bureau International des Poids et Mesures.
The BIPM and the evolution of the definition of the metre. URL accessed on
2006 June 3.
★
Resolutions of the CGPM. URL accessed on
2006 June 3.
★ Penzes, William B. at the U.S. National Institute of Standards and Technology Precision Engineering Division (
2005 December 29).
Time Line for the Definition of the Meter. URL accessed on
2006 June 3.
★ U.S. National Institute of Standards and Technology (October 2000).
The NIST Reference on Constants, Units, and Uncertainty: International System of Units (SI):
★
★
SI base units. URL accessed on
2006 June 3.
★
★
Definitions of the SI base units. URL accessed on
2006 June 3.
★
★
Historical context of the SI: meter. URL accessed on
2006 June 3.
Notes
1. Resolution 1 of the seventeenth CGPM (1983): Definition of the metre
2. Reference: ''Time Line for the Definition of the Meter'' by the NIST.
3. NIST-F1 Cesium Fountain Atomic Clock.
External links
★
Length—Evolution from Measurement Standard to a Fundamental Constant at U.S. NIST
★
The History of the Meter By Tibo Qorl (Translated by Sibille Rouzaud)