
Two 'F/A-18C Hornets' on the
carrier deck. Note the prominent leading edge extensions on this aircraft.

Flow visualization smoke marks vortex flows along an F/A-18's leading edge extensions
'Leading edge extensions' or 'LEX' (also referred to as ''leading edge root extensions'' or ''LERX'' or ''strakes'') are
fillets added to the front of a modern
fighter aircraft's
wings in order to provide usable
airflow at high
angles of attack. They are typically roughly triangular in shape, running from the leading edge of the
wing root to a point near the
cockpit along the fuselage. They tend to be fairly small in span, extending out less than a metre. In effect, they are small
delta wings grafted onto the front of the normal wings.
In cruising flight the effect of the LEX is minimal. However: when the angle of attack increases, as in a
dog fight, the LEX starts to generate a high-speed
vortex that remains attached to the top of the wing. Due to the effects described by
Bernoulli's principle the wing therefore has a low pressure zone on top, and continues to generate lift past the normal
stall point. The
F/A-18 Hornet has especially large examples of LEX, as does the
Sukhoi Su-27. Early prototypes of the Su-27 crashed due to poorly designed LEX, causing it to freeze at angles of attack above 5 degrees. This has since been overcome. In fact, the LEX help in making advanced maneuvers such as the
Pugachev's Cobra, the
Cobra Turn and the
Frolov Chakra possible.
Airplanes using LEX
A few examples of aircraft with leading edge extensions are listed below.
★ Russia/USSR
★
★
Sukhoi Su-27 and derivatives, including the
Sukhoi Su-34
★
★
Mikoyan MiG-29
★ USA/UK
★
★
F-5 Freedom Fighter
★
★
F-16 Fighting Falcon and its unsuccessful competitor the
YF-17 Cobra
★
★
F/A-18 Hornet
★
★
AV-8 Harrier II/
RAF Harrier II
★ Civilian
★
★
Quest Kodiak (Fixed Discontinuous Outboard Leading Edge Extension)
Similar concepts
A concept similar to LEX can be found on many aircraft, including
airliners. These '
vortex generators' take the form of small fins sticking up from the surface of the wing just behind the leading edge. In this case the purpose is to generate small vortices that ensure airflow over the
control surfaces at high angles of attack, typically during takeoff and landing.
Another way to prevent stalling at high angles of attack is to use
canards. They can be used in conjunction with leading edge extensions, as is shown in the
Sukhoi Su-33.