
Landing craft ''Rapière''
'Landing craft' are
boats and seagoing vehicles used to convey a
landing force (
infantry and
vehicles) from the sea to the shore during an
amphibious assault. Most renowned are those used to storm the beaches of
Normandy, the
Mediterranean, and many
Pacific islands during
WWII.
In the days of sail, the ship's boats were used as landing craft, but the introduction of
steamships led to ship's boats shrinking in size, which required the creation of specialist designs for landing purposes.
The High Summer of the landing craft was the latter half of
WWII, when a large number of different designs were produced in large quantities by the
United Kingdom and
USA.
Because of the need to run up onto a suitable beach they were flat-bottomed, and many designs had a flat front, often with a lowerable ramp, rather than a normal
bow. This made them difficult to control and very uncomfortable in rough seas.
The control point (
bridge was far too fancy a description for the facilities of the LCA and DUKW) was normally situated at the extreme rear of the vessel as were the engines.
In all cases they tended to be known by an
abbreviation derived from the official name rather than the full title.
Types
The "
Landing Craft Control" (LCC) were 56-foot USN vessels, carrying only the crew (Scouts and Raiders) and newly-developed radar. Their main job was to find and follow the safe routes in to the beach, lanes which had been cleared of obstacles and mines. There were 8 in the entire Normandy invasion (2 per beach). After leading in the first wave, they were to head back out and bring in the second wave. After that, they were used as all-purpose command and control assets during the invasion.
The smallest landing craft were amphibians such as the
US-designed
DUKW, basically an amphibious truck, and the
Landing Vehicle Tracked, an amphibious armoured personnel carrier. These were operated by Army personnel, not naval crews. They had a capacity of about 3 tons. The British introduced their own amphibian the
Terrapin into use after the landings.
Of the landing craft proper the smallest were the US '
Landing Craft Personnel, Large Large' (10 tons) and the British '
Landing Craft Assault' (LCA) (13 tons). These were small craft intended to be transported around by larger vessels then lowered into the water off the target beach. Typically they could carry 36 fully armed soldiers. The LCPL sometimes came with an enclosed cockpit and was often used as a command boat. It lacked a loading ramp which the LCA did have.
The US '
Landing Craft Vehicle/Personnel' (LCVP) was a more flexible variant of the LCPL with a wide ramp- it could carry 30 troops or small vehicles such as Jeeps.
'
Landing Craft, Mechanized' were larger (36 tons), capable of carrying one small
tank or 100 troops.
None of the above was capable of making a voyage longer than about 6-12 hours, mainly through fuel limitations.
196.jpg)
LCI(L) 196 and a DUKW during the Invasion of Sicily 1943 (World War II)
Then came the
Landing Craft Infantry (LCI), capable of making serious voyages under its own power (some were sailed directly from the
United Kingdom to take part in the
Operation Torch landings, and US Navy LCIs
island-hopped across the Pacific). LCIs were about 158 feet long and 23 feet wide and carried around 200 troops. There were several sub-types of the craft, with the LCI(L) (L for large) infantry carrier dominating; but LCIs also served as rocket (LCI(R)) and mortar (M), and gunboat (G) platforms, as well as a flotilla flagship (FF). While still intended to run up on the beach, these tended to have a normal type bow with stepped ramps each side for the troops to disembark. The LCI was re-classified Landing Ship Infantry (LSI) by the US in 1949.
Of a similar size was the
Landing Craft Tank, which could carry up to 4
Tanks or other vehicles. These had a ramp at the front which was dropped for the vehicles to get ashore. Behind the ramp was an open space known as the ''Tank Deck''. There were several different designs and sizes varied.
The next step was the
Landing Ship Tank. This carried rather more vehicles than the LCT (20 in the US-built versions) and had normal looking bows, although the bows were actually formed by doors which were opened for the unloading ramp to drop. Fully loaded, these displaced more than 3,000 tons, rather more than any
Royal Navy destroyers of the period.
Finally there was the
Landing Ship Dock, which had a large open compartment at the back. Opening a
stern door and flooding special compartments allowed this area to be open to the sea and LCI-sized vessels could enter or leave.
Initial
British nomenclature used different type names leading to alternate names such as Assault Landing Craft, Infantry Landing Craft and Tank Landing Craft.
Due to their rather small size the majority were not given names and were simply given serial numbers, e.g. ''LCT 304''. The LSDs were an exception to this being much the same size as a small
cruiser. Three British-built LSTs were named as well,
HMS ''Boxer'',
''Bruiser'' and
''Thruster'' which were somewhat larger than the US design; they also had proper funnels.
Armament
DUKWs, LCAs and LCMs had no fixed armament, but there were ways for troops on board to use their own weapons.
LCIs and LCTs carried weapons such as the
Oerlikon 20 mm cannon each side of the bridge structure. LSTs had a somewhat heavier armament.
Special purpose craft
Some Landing craft were converted for special purposes either to give defence for the other landing craft in the attack or as support weapons during the landing.
Landing Craft Assault (Hedgerow)
The LCA(HR) was a conversion of the British LCA which carried 24
spigot mortars, the Royal Navy's
Hedgehog anti-submarine weapon instead of personnel. The mortars were fired as a barrage onto the beach to clear mines and other obstructions. Having discharged its mortars and its duty the LCA(HR) would then leave the beach area. They were towed to the beach by larger craft such as the LCT which would carry the assault teams of the
Royal Engineers with their
specialist vehicles and equipment to complete the beach clearance.
Landing Craft Flak
The Landing Craft Flak (LCF) was a conversion of the LCT intended to give
anti-aircraft support to the landing. They were first used in the
Dieppe Raid early in 1942. The ramp was welded shut, and a deck built on top of the Tank deck. They were equipped with several light anti-aircraft guns—a typical fitting was eight
20 mm Oerlikons and four
QF 2 pdr "pom-poms" and had a crew of 60. Royal Navy examples had mixed crews, with the operation of the craft being the responsibility of RN crew and the manning of the guns being done by
Royal Marines. They carried two naval officers and two marine officers.
Landing Craft Gun
The Landing Craft Gun (LCG) was similar and was intended to give supporting fire to the landing. Apart from the Oerlikons as per a normal LCT they had two 4.7 inch destroyer guns. Crewing was similar to the LCF. LCGs played a very important part in the
Walcheren operation in October 1944.
Landing Craft Rocket
Finally there was the Landing Craft Rocket, known as the Landing Craft Tank (Rocket) (LCT(R)) to denote that it was a modified LCT rather than LCR.
This had a large set of launchers for the British
RP-3 60 lb (27 kg), 3 in (76 mm) rockets mounted on the covered-over tank deck. The full set of launchers was "in excess of" 1,000 and reloads totaling 5,000 rockets were kept below. The firepower was claimed to be equivalent to 80
light cruisers or 200 destroyers.
The method of operation was to anchor off the target beach, pointing towards the shore. The distance to the shore was then measured by
radar and the elevation of the launchers set accordingly. The crew then vanished below (apart from the commanding officer who retreated to a special cubby hole to control things) and the launch was then set off electrically. The launch could comprise the entire set or individual ranks of rockets.
A full reload was a very labor-intensive operation and at least one LCT(R) went along side a cruiser and got a working party from the larger ship to assist in the process.
Amphibious mechanized utility and landing craft
The mechanized utility and landing craft, more commonly known as an amphibious landing craft or boat. This was the kind used during the second world war, and while the mechanized landing crafts of today are similar in construction, a lot of improvements have been made. Normally using diesel engines, the best amphibious landing boats (such as the
LCM 8 of the
US Navy) are capable of a
military lift of 183 metric tons at a speed of 22 km/h, carrying even heavy equipment like
M1 Abrams tanks with little trouble. Amphibious landing craft normally mount several
machine guns or similar weapons for the defense of troops and/or vehicle crews inside.
Landing Craft Air Cushioned (LCAC)

LCAC
The air cushioned landing craft, or fully amphibious landing craft, is a more modern variation on the amphibious landing boat. These craft are based on small to mid sized multi-purpose
hovercraft, also known as "over the beach" ("OTB") craft. This allows troops and material to access more than 70% of the world's coastline, while only approximately 15% of that coastline is available to conventional landing craft. Typical barriers to conventional landing craft are soft
sandy
beaches,
marshes,
swampland, and loose surfaces. Air cushion technology has vastly increased the landing capability of the craft, providing greater speed and flexibility over traditional landing craft.
Like the mechanized landing craft, they are usually equipped with mounted
machine guns, although they also support
grenade launchers and heavy weapons.
These vehicles are commonly used in the
United States Navy, which first received them in 1984, the
United Kingdom's
Royal Navy, and some other modern fighting forces such as the
Russian Navy. Forces that use the LCAC include the
Royal Marines. Also
Hellenic Navy use the Russian design
Zubr/Pomornik (LCAC) which is the biggest military hovercraft.
Landing barges
Landing barges were adaptations of British
Thames barges and
lighters as landing craft. In size they came between the landing craft and landing ships. They were used at all beaches during the landings at Normandy manned by British crews.
Some were fitted with engines while others were towed to the beach. They were used for defence, transportation, supply (food, water and oil) and repair (fitted out with workshops).
Those fitted for vehicle carrying had a ramp fitted in place at the rear and they had to back onto beaches. They would work from ships and coasters to the shore and back.
Two flotillas were made up of "Flak barges" to provide defence of the beaches. Like landing craft, flak barges carried A/A guns: two
40 mm Bofors and two
20 mm Oerlikon, with army gunners and naval crew.
The "Landing Barge Kitchen" (LBK) was fitted with a large superstructure containing the galley. With a crew of 20 plus they could carry food for 900 for a week and provide 1,600 hot and 800 cold meals a day, including freshly baked bread.
[1]
See also
★
Royal Marines Landing Craft Specialisation
★
Balikpapan class LCH
★
Ramped Craft Logistic
External links
★
Navy Fact File: Landing Craft, Air Cushioned
★
Landing Craft Infantry (LCI) Assn. (usslci.com)
★
NavSource.org Landing Craft Infantry (LCI) Data and Photo Index
★
USS Rankin (AKA-103): Her Landing Craft
References
★
U.S. Amphibious Ships and Craft: An Illustrated Design History, by Norman Friedman