Discover

'EDVAC' ('''E'lectronic 'D'iscrete 'V'ariable 'A'utomatic 'C'omputer'') was one of the earliest electronic computers. Unlike its predecessor the ENIAC, it was binary rather than decimal, and was a stored program machine.

Contents

Project origin and plans

Technical description

Installation and operation

References

Project origin and plans

ENIAC inventors John Mauchly and J. Presper Eckert proposed the EDVAC's construction in August 1944, and design work for the EDVAC commenced before the ENIAC was fully operational. The design would implement a number of important architectural and logical improvements conceived during the ENIAC's construction and would incorporate a high-speed serial access memory. Like the ENIAC, the EDVAC was built for the U.S. Army's Ballistics Research Laboratory at the Aberdeen Proving Ground by the University of Pennsylvania's Moore School of Electrical Engineering. Eckert and Mauchly and the other ENIAC designers were joined by John von Neumann in a consulting role; von Neumann summarized and elaborated upon logical design developments in his 1945 ''First Draft of a Report on the EDVAC''.^[1]
A contract to build the new computer was signed in April 1946 with an initial budget of US$100,000. The contract named the device the Electronic Discrete Variable Automatic ''Calculator''. The final cost of EDVAC, however, was similar to the ENIAC's, at just under $500,000, five times the initial estimate.

Technical description

The EDVAC was a binary computer with automatic addition, subtraction, multiplication, programmed division and automatic checking with a memory capacity of 1,000 44-bit words (later set to 1,024 words, thus giving a memory, in modern terms, of 5.5 kilobytes).
Physically, the computer comprised the following components:

★ a magnetic tape reader-recorder

★ a control unit with an oscilloscope

★ a dispatcher unit to receive instructions from the control and memory and direct them to other units

★ a computational unit to perform arithmetic operations on a pair of numbers at a time and send the result to memory after checking on a duplicate unit

★ a timer

★ a dual memory unit consisting of two sets of 64 mercury acoustic delay lines of eight words capacity on each line

★ three temporary tanks each holding a single word
EDVAC's addition time was 864 microseconds and its multiplication time was 2900 microseconds (2.9 milliseconds).
The computer had almost 6,000 vacuum tubes and 12,000 diodes, and consumed 56 kW of power. It covered 490 ft² (45.5 m²) of floor space and weighed 17,300 lb (7,850 kg). The full complement of operating personnel was thirty people for each eight-hour shift.

Installation and operation

EDVAC was delivered to the Ballistics Research Laboratory in August 1949. After a number of problems had been discovered and solved, the computer began operation in 1951 although only on a limited basis. Its completion was delayed because of a dispute over patent rights between Eckert and Mauchly and the University of Pennsylvania, resulting in Eckert and Mauchly's resignation and departure to form the Eckert-Mauchly Computer Corporation and taking most of the senior engineers with them.
By 1960 EDVAC was running over 20 hours a day with error-free run time averaging eight hours. EDVAC received a number of upgrades including punch-card I/O in 1953, extra memory in slower magnetic drum form in 1954, and a floating point arithmetic unit in 1958.
EDVAC ran until 1961 when it was replaced by BRLESC. During its lifetime it proved to be reliable for its time and productive.

References

1. "First Draft of a Report on the EDVAC" (PDF format) by John von Neumann, Contract No.W-670-ORD-4926, between the United States Army Ordnance Department and the University of Pennsylvania. Moore School of Electrical Engineering, University of Pennsylvania, June 30, 1945. The report is also available in From ENIAC to UNIVAC: An Appraisal of the Eckert-Mauchly Computers, , Nancy, Stern, Digital Press, 1981, .